Wallenstein FX Series, Руководство пользователя, Страница: 4 / 11

FX Series
tele Radio® Transmitter & Receiver
4
Remote Winch Control
Power Off Button (4)
Push to turn the transmitter off.
I/O Button
The I/O Button on the back of the
transmitter disconnects the power
supply from the batteries. The switch
must be in the 'I' position for the
transmitter to operate. In the 'O'
position, the transmitter cannot be
used.
When storing the winch for a period of time, the switch
should be moved to the 'O' position to save battery
life. Turn the switch to the 'O' position when changing
batteries.
IMPORTANT! Do not use the I/O button to
start or stop the transmitter. Use the On and Off
buttons instead.
2. Receiver
The receiver is mounted on the winch safety screen.
The signal from the transmitter to the receiver is sent to
the hydraulic actuator to engage/disengage the winch
clutch. It requires a 12 VDC power connection from
the tractor. The receiver enclosure is weather, vibration
and shock resistant.
A manual override switch on the receiver permits
engaging/disengaging the winch clutch in the event the
transmitter is not functioning.
00834
2 3
1
Fig. 3 – Receiver
1. Receiver
2. Manual override button
3. Storage mount for transmitter
3. Manual Override
The winch can be operated manually with the button
on the front of the receiver.
CAUTION!
Do not risk personal injury by standing in front of
the winch during operation. Do not use manual
override unless winch operation is necessary
and the remote is not functioning.
W050
Because of the location of the switch, the manual
override control must not be used on a continuous
basis and should only be used until the remote is back
in service. Be aware of the cable and load to avoid
potential injury.
4. Transmitter Operation
Press and hold the ON button until
the green LED turns on, then release.
The green LED flashes rapidly when
communication has been established
with the receiver. It flashes slowly
if the receiver is off or there is
no communication between the
transmitter and receiver.
Press and hold the UP arrow to retract
the winch cable.
Release the button to disengage the
winch and stop the cable retracting.
00833
Fig. 4 – Remote Transmitter operation