Wallenstein FX Series, Руководство пользователя

Страница: 3 / 11

FX Series
tele Radio® Transmitter & Receiver
3
Remote Winch Control
Remote Winch Control
The remote winch control provides a means of
engaging/disengaging the spring-loaded clutch at a
distance from the winch.
00832
1
2 3
Fig. 1 – Remote Winch Control System
1. Hand-held Transmitter
2. Receiver
3. Manual Override Switch
1. Hand-held Transmitter
CAUTION!
• Never leave a transmitter unattended.
•
Always switch the transmitter off when not in
use. Store in a safe place.
• Keep a clear view of the work area at all
times.
W054
Each transmitter is pre-programmed with a unique
code. The receiver is programmed to respond only to
that transmitter. Other radio-controlled systems can
therefore work in close proximity without interference.
The transmitter has two replaceable 1.5 V, AAA
non-rechargeable alkaline batteries. The batteries are
accessed by removing the rear panel.
IMPORTANT! Do not recharge the batteries.
Attempts to recharge may cause rupture or
hazardous liquids to leak, causing damage to the
equipment.
There are three LED indicators on the transmitter. The
(center) green LED flashes to indicate communication
between the transmitter and the receiver. The red
LEDs flash to indicate low battery or a system error.
1
4
6
5
2
3
00830
Fig. 2 – Hand-held Transmitter
1. Power ON Button
2. Clutch Engage Button
3. LED Indicator Lights
4. Power OFF Button
5. I/O Switch
6. (not used)
Power On (1)
Push to turn on the transmitter.
Clutch Engage (2)
Push and hold to activate the winch
(retract the cable). The transmitter
sends a signal to the receiver once
pressed. The winch stops when the
button is released.
LED Indicator lights (3)
These LEDs indicate system status. The center LED is
green during normal operation. When 10% of battery
life remains, it lights red. The left- and right-hand LEDs
are red and come on to indicate a system error.