Wallenstein CT16B, Руководство оператора

Страница: 37 / 48

8.2 Maintenance Schedule
Perform maintenance procedures at time shown or hour
interval, whichever comes first.
As Required
Remove any entangled material from conveyor
Check that all fasteners are tight.
Every 8 hours or at Each Use
Check fuel level See page 24
Check engine oil level. See page 24
Check reduction case oil level See page 28
Every 50 hours or Annually
Clean engine air filter See page 25
Grease conveyor drive bearings See page 37
Check conveyor chain tension See page 37
Every 100 hours or Annually
Change engine oil See engine manual
Check tire pressure
See rating on tire
sidewall
Change reduction case oil See engine manual
Change engine air filter See page 25
Clean machine. Remove debris
and entangled material.
—
Change fuel filter See engine manual
Check drive belt tension. See page 38
Check conveyor chain tension Seepage 37
Grease hand winch See page 39
8.3 Honda Engine
8.3.1 Engine and Reduction Case Oil
Change
Refer to engine manual for procedure. Change oil every six
months or 100 hours.
8.4 Grease Points
Use a hand-held grease gun for all greasing. Pump one shot
of grease slowly into each fitting.
• Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
• If fittings do not take grease, remove and clean them
thoroughly. Replace grease fittings as necessary.
Location
Grease Points
– Every 50 hours of operation
or annually
1 Driven shaft bearings–1 per side
00458
Fig. 47 –
Grease Points
1
IMPORTANT! Do not over grease. Pumping more than
one shot from a grease gun into the bearings can push the
grease out of the seals. Doing that repeatedly can damage
the seals. Grease is not kept in, and dirt and moisture are
not kept out.
8.5 Chain Tension, Adjust
The conveyor chain can stretch a slight amount and can require
occasional adjustment. Be careful not to over adjust the chain.
That adds pretension into the chain and reduces chain life.
CT16B / CT24B
Trailer Firewood Conveyor
Service and Maintenance
37