Wallenstein CT16B, Руководство оператора

Страница: 30 / 48

00463
Fig. 34 –
1/3 Throttle
4. Turn the engine ignition switch ON.
00187
Fig. 35 –
Ignition Switch
5. Pull the starter grip out lightly until resistance is felt, then
pull briskly in the direction of the arrow as shown below.
Return the starter grip gently.
00192
Fig. 36 –
Recoil Starter
IMPORTANT! Do not allow the starter grip to snap back
against the engine. Return it gently to prevent damage to the
starter.
6. Leave the engine operating at low throttle for a few minutes
to allow it to warm up. Gradually push the choke control
lever open (to the left) as the engine warms.
IMPORTANT! Warm up the engine before putting to work.
7. Once the engine is warm, increase throttle as required.
Adjust engine speed to preferred conveyor off-load speed.
7.2 Vanguard Engine – Starting
IMPORTANT! If the engine does not start after
repeated attempts, contact your local dealer or go to
VanguardPower.com
.
1. Make sure the machine is level and in a stable position.
2. Move the choke control to the CLOSED position. Choke is
usually unnecessary when starting a warm engine.
3. Move the throttle control to the FAST position.
01852
Fig. 37 –
name
4. Firmly grip the starter-cord handle. Pull the starter cord out
slowly until you feel resistance, then pull rapidly.
01853
Fig. 38 –
Recoil Starter
5. As the engine warms up, gradually push the choke control
lever open (to the right).
Operating Instructions
CT16B / CT24B
Trailer Firewood Conveyor
30