Wallenstein 720124, Руководство оператора

Страница: 28 / 44

Operating Instructions
WXR720/L, WXR740/L
Trailer Wood Splitter
28
Return the starter grip gently.
00192
Fig. 23 – Recoil Starter
IMPORTANT! Do not allow the starter grip to snap back
against the engine. Return it gently to prevent damage to the
starter.
6. Leave the engine operating at low throttle for a few minutes
to allow it to warm up. Gradually push the choke control
lever open (to the left) as the engine warms.
IMPORTANT! Engine should be warmed up before putting to
work.
7. Once the engine is warmed, increase the throttle setting to
MAX before beginning.
6.11 Stopping the Engine
To stop the engine in an emergency, turn the ignition switch OFF.
Correct fault situation before restarting.
00187
Fig. 24 – Ignition Switch
Under normal conditions, use the following procedure
1. Stop loading material onto the splitter bed.
2. Decrease engine speed to MIN.
3. Turn the ignition switch OFF.
6.12 Log Placement
WARNING!
Risk of pinching or crushing hazard between the
wedge or push block and the log!
Never place hands at the ends of the log.
Always grasp logs by the sides when loading or
removing.
W035
• Always grasp the log by the sides not the ends when
placing in or removing logs from the splitter. This
minimizes the chance of the operator getting fingers, hands
or arm between the wedge / push block and the log.
• Any logs or debris remaining on the splitter bed should only
be removed after it is safe to do so.
00204
Fig. 25 – Correct Log Placement