Wallenstein 1C34423, Руководство оператора

Страница: 27 / 44

BXC34
Cart Chipper
Operating Instructions
27
6.12.2 Moving the Chipper
The chipper is designed to be moved easily by leaning it back on
its wheels using the handholds in the shredder intake chute.
• Disengaged the clutch and shut the engine down before
moving.
IMPORTANT! The engine manufacturer recommends
turning the engine off before tilting the chipper. Tilting it can
cause a low oil level situation.
• Lean the chipper back onto its wheels and reposition.
IMPORTANT! When moving the chipper, avoid sharp turns.
Abrupt turns could damage the tires.
01185
Fig. 28 –
Feed Chute Handholds
6.13 Unplugging the Chipper
Although the machine is designed to handle a wide variety of
material without any problem, occasionally it could plug up. If
that happens, follow this procedure to clear it:
1. Disengage the drive, turn the engine off and wait for all
moving parts to stop.
2. Pull material out of the chipper feed hopper. Make sure
nothing is jammed or wedged between the input opening
and the rotor.
3. Pull the material out of the discharge chute. Use a stick to
poke loose any material jammed into the discharge chute.
4. Start the engine, engage the drive system and check to see
if the jam is cleared.
If the jam did not clear, proceed to
Step 5.
5. Disengage the drive, turn the engine off and wait for all
moving parts to stop.
6. Remove the upper rotor housing.
7. Remove material from inside the rotor compartment.
CAUTION!
Avoid reaching into rotor compartment. Rotor
chipper blades are very sharp. If reaching inside
is necessary, use extreme care.
W003
01192
Fig. 29 –
Remove Upper Rotor Housing
8. Clean out the discharge and rotor.