Wallbox PULSAR, Руководство по установке

Страница: 6 / 20

PULSAR
- installation guide
CONNECTOR RECOMMENDATIONS
Always check the charging cable and contacts for damage and dirt before using them.
Never use a damaged charging cable, vehicle inlet, or infrastructure socket outlet for charging
Never use contacts that are dirty or wet.
Only connect the charging cable to vehicle inlets and infrastructure socket outlets that are protected against water, moisture and liquids.
After stopping the charging process the vehicle connector and the infrastructure plug can be disconnected. Never use force to disconnect the
vehicle connector from the vehicle inlet and the infrastructure plug from the socket outlet. Such dangerous actions can lead to serious
injuries or even death.
Depending on the charging station and the electric vehicle the termination of the charging process and the duration of unlocking may vary.
There are electric vehicles that can be started with a connected charging cable. Always make sure to disconnect the charging cable before
driving away.
Do not use the charging cable with an extension cable or an adapter.
If the connector emits smoke or starts melting, never touch the charging cable. If possible, stop the charging process. In any case, disconnetc the power
supply of the Wallbox charger.
Make sure that the charging cable is out of reach of children. The charging cable may only be used by persons with a valid driver's license for motor
vehicles.
Be particullary careful with the connector, do not step on it or its cable.
The cable must NOT UNDER ANY CIRCUMSTANCES be strained when connected to the vehicle.
en 6
SAFETY INSTRUCTIONS 2/2