6
3.
4.
Connect the ribbon cable to the connector
on the Control board and close the charger.
Place the Control board and the LED Halo on
the new front plastic cover and screw the 12
screws that were removed while detaching the
control board and LED Halo from the cover.
1.
2.
Attaching the new plastic cover
Insert and then tighten the Torx screw in the
bottom of the charger to secure the front
plastic cover and restore the power supply to
the charger.
Position the top clip points of the cover on
the charger body. Clip first the lateral clips to
the charger body and then the bottom clips.
Restore the power supply to the charger.
5.
Содержание PULSAR
Страница 1: ...PULSAR Service Manual...
