Wallbox Pulsar Plus, Руководство по установке

Страница: 6 / 29

10 11
EN EN
x2
x2
1.
Using a wall stud finder, find the wall stud
nearest to the NEMA outlet. Mark a vertical line
approximately 20” (50cm) in length in line with
the wall stud.
1.
Carefully remove your charger from the
packaging box and hang your charger from the
top of the wallplate.
2.
Ensure that the placement of the NEMA
outlet and your charger will allow for an adequate
connection of the 12” (30cm) NEMA cable.
4.
Unplug your charger and carefully place it
back in the packaging box while you continue.
3.
Carefully lift the charger from the box, plug
the NEMA cable into the outlet, and position the
charger centered on the vertical line. Position the
charger such that the NEMA cable has a gentle
curve and is not stretched. Mark a horizontal line
at the bottom of the charger.
Placement
Make sure the outlet is powered off!
ø6 x 50mm
Ensure the NEMA receptacle is correctly installed before connecting your charger. See instructions on Page 9.
≈ 8
”
≈ 20 cm
x2
Mounting
ø3.5 x 9.5mm
1.
Remove the tape from the wallplate to detach
it from the charger.
2.
Place the wallplate with the bottom edge
aligned with the horizontal line and the center
holes aligned with the vertical line. Mark the
location of the holes.
4.
Firmly mount the wallplate using the provided
wall screws. Do not over-tighten the screws.
3.
Drill two holes with an appropriate sized bit.
Place the wallplate in alignment with the holes.
Installing the wallplate
2.
Secure the charger to the wallplate using
the provided wallplate screws. Do not over-
tighten.
Follow our recommendations
for location and positioning
the charger in page 8.
Proceed to the instructions for installing the
holster and operating your charger, pages
16-17.
If you are mounting your charger on a solid wall,
use the wall anchors provided with your charger.
Alternately you may find a suitable location on
a solid wall.
INSTALLATION INSTALLATION
NEMA plug-in installation NEMA plug-in installation