Wallbox DC Charger 1ph, Руководство по установке

Страница: 13 / 20

13
1.b Lower connection
1. Insert the four anchors into each respective hole.
2. Place the wallplate in its position.
3. Fix the wallplate with four 6x30mm screws.
4. At the lower side of the connector box, there is an area with a thinner wall can be found; use a
cutter or any sharp tool and make an incision for entry of the cable.
5. Remove the four screws from the connector box and open it.
6. Remove the screws of the cable clamp.
7. Carefully and firmly insert the power cable through the sealing.
8. Connect the power cables in the right positions (see picture 1.2).
9. Firmly fix the cables with the clamp and its screws.
10. Close the connector box and screw it.
11. Make sure the previous steps have been completed correctly
Precautions
• The colors shown are not subject to international standards. Always check the correct
connection.
• Always use standard cables that can drive the current that has been setup in the current
selector.
• Always connect the protective earth.
• Check that the Wallplate is firmly fixed to the wall before mounting the charger.
2. Installing the Plug holder
1. Insert the two anchors into each respective hole.
2. Place the plug holder in its position.
3. Fix the plug holder with two 6X30mm screws
Plug holder Picture 2.1