![background image](http://html1.mh-extra.com/html/wallas/90-t/90-t_manual_3234498058.webp)
90 t / 800 t
490527A
- 58 -
en
Installation
Heater installation
The country specific regulations shall be followed in the installation.
The warranty of boat products is valid only in boat installations.
The warranty is not valid in installations to vehicles or other spaces.
The device is meant for free time use in pleasure boats. The device is not designed
for continuous use for example in live aboard boats. In such use the warranty is not
valid.
Things to note when selecting the installation location
The device shall be installed into a dry space in inside location.
When installing the device, bear in mind that the device must be detached for
maintenance. Therefore, it is advisable to make the connections easy to open and
disconnect.
The stove should be installed level. The inclination must not exceed 5°. While the
device might not break if it is temporarily tilted to a steep angle (even for some
hours), the burner will not yield optimal performance if it is constantly inclined.
Also consider where you will place the control panel, as the length of the control
panel’s cable may pose some limitations.
Please note specially the following things:
•
Avoid installing the control panel in the immediate vicinity of a water outlet.
•
If possible, install the control panel on a vertical surface.
•
Moreover, the stove should not be installed on top of a refrigerator. The stove
will heat its surroundings and thus decrease the power of the refrigerator.
We recommend that the device be installed by an authorised Wallas service shop.
Things to note when installing pipes, hoses and cables
Power cables and fuel hoses must be protected in locations where they are sus-
ceptible to mechanical damage due to sharp edges or heat.