1. Manual Landing, AUTO Landing or Return to Home function landing.
2. First, turn off the 3 batteries one by one, then turn off the remote controller.
3. Finally, remove the battery from the aircraft.
18
13.0 End flight
14.0 Additional remarks
14.2 Compass Calibration
14.1 Camera Gimbal Removal and Installation
Removal
Loosen the M3x3 fixed gimbal screw first, then
turn the gimbal nut clockwise to the unlocked
position to pull down the Gimbal
Put the white mark position column aim at the white mark position
hole, and put the gimbal in the install position upwards embed.
Rotate the gimbal nut to the locked position following to the direction
of the arrow.Tighten M3x3 screw to fix the gimbal.
Installation
If there is circles or drift in flying, please calibrate the compass.
(the motor must be locked and the red and blue LED lights turn off )
Please calibration outdoors and far away from strong electromagnetic interference.
The compass calibration steps are as follows:
Place right/left sticks at lowest
location, toggle them inward and
keep for 5 seconds until the aircraft’s
red LED lights flash quickly .
Horizontal 360°rotation of aircraft
until red LED lights turn off and
blue LED lights flash quickly.
In case of failure to calibrate, please follow above procedure to repeat calibration.
Tail toward operator
Quick Start Guide
Keep for 5 seconds
Ground
heading
Vertical 360° rotation of aircraft
(heading down) until blue LED
lights turn off, indicating successful
calibration, and place aircraft at a
horizontal location
Screw
hole
position
