Walker B27i, Руководство оператора

Страница: 40 / 76

Operating Instructions B27i
36
NOTE: The emergency stop procedure is exactly
the same procedure used to normally stop and
park the machine.
ADJUSTING CUTTING HEIGHT
WARNING
The engine must be stopped before
ad justing cutting height. Disengage the
blade clutch (PTO), engage the parking
brake, stop the engine, and remove the ig-
nition key. Wait for all move ment to stop
before getting off the seat.
Cutting height is adjusted by positioning the four
(4) retainer hitch pins in a series of six vertical
holes on the deck support pins. Lift handles have
been pro vided on each end of the deck to assist in
raising the deck while positioning the hitch pins.
Cutting heights range from 1.5 in. (38 mm) [top
holes] to 4 in. (102 mm) [bottom holes] in 1/2 in.
(13 mm) increments.
Lift Handle
Deck Support
Pin
Hitch Pin
Washer
Cutting Height Adjustment
TRANSAXLE LOCKOUT
IMPORTANT: DO NOT TOW this mower faster
than 2 mph (3.2 km/h) with the transaxle lockout
engaged. Towing can produce excessive internal
pressure and damage the transaxle(s).
To move the mower with the engine NOT running
(dead battery, maintenance, etc.), the transaxles
need to be unlocked (released).
1. Raise the seat panel.
2. Pull up on each transaxle lockout arm and
move toward the center of the machine to
engage the step that holds the arm in the UP
(unlocked) position.
3. The mower will “freewheel” with the arms in
the LOCKOUT position. The levers must be in
the highest position to completely unlock the
transaxles.
Transaxle Lockout Arm
Transaxle Lockout Arm - Freewheel Position
4. After moving the mower, release the arms,
placing them down in the normal OPERATING
position. The transaxle lockout arm ends
should be completely retracted against the
chassis, otherwise operation of the transaxle
may be erratic.
Transaxle Lockout Arm
Transaxle Lockout Arm - Normal Operating
Position