Walker 42", Руководство оператора

Страница: 19 / 40

OPERATION
OM 0182SB-A 17
G
ENERAL
P
REPARATION
1.
Read this Operator's Manual carefully. Be
thoroughly familiar with the controls and
proper use of the equipment. Know how to
stop the unit and disengage the controls
quickly.
2.
Make sure the snowblower is clear of snow
before engaging the driveline.
3.
Make sure that the auger and fan operate
freely.
4.
Make sure there is no oil leakage on worm
gearbox. Maintain proper oil level with
extreme pressure oil, AGMA 5EP or
SAE 90.
5.
Adjust skid shoes so that the snowblower
runs level.
6.
Wear proper winter attire when using this
equipment.
O
PERATING
C
ONTROLS
Deflector Adjustment
Adjust deflector angle according to the distance
the snow must be thrown. To adjust, loosen
the two knobs, adjust to the desired angle then
tighten knobs securely.
Engine Speed
Use only moderate engine speed when
engaging tractor PTO. Engaging at high speed
will shorten the driveline life. For maximum
power, operate the engine at or near full
throttle.
Manual Rotation
Adjust chute orientation by turning the rotation
handle.
Increasing Traction and Stability
The use of tire chains and counterweights is
recommended for extra traction and stability,
especially when operating in snow and/or on
slippery surfaces. See your dealer for details.
WARNING : To ensure safety, make sure
tractor engine and snowblower come to a
complete stop and tractor PTO is disengaged
BEFORE making any adjustments.
PTO
The snowblower is driven from the tractor PTO. It is
engaged by pulling up the tractor PTO switch. To
disengage, push down the PTO switch to the "OFF"
position.
Snowblower Pitch Adjustment
The snowblower must be installed on subframe and
leveled to the ground BEFORE making adjustment.
The snowblower pitch angle (

) can be adjusted by
loosening bolts (Fig. 11, items 5 and 6) of
" Attaching
Blower to Tractor "
section, setting the desired angle
and tightening the bolts.
The pitch angle (

) should
be set to maximum (greater than 90

).
Skid Shoes Adjustment
Adjust the snowblower so that the skid shoes run
level and according to the surface conditions so that
stones are not thrown with the snow. Adjust both
skid shoes to the same height to keep the cutting
edge level and adjust upwards for smooth surfaces.
Loosen skid shoe bolts and adjust according to
instructions below, and securely tighten bolts:
Clearance between cutting edge and surface

Level paved surface: Adjust to 1/16" to 1/8" (2 to
5 mm)

Uneven or gravel surface: Adjust to 1/2" to 5/8"
(13 to 16 mm).