18
Section 4:
Mechanical Installation
Connecting the pre-filter to the dryer
PD0046 – PD0360 models
•
Attach pre-filter (purchased separately) utilising a pipe
nipple and/or pipe adapter.
•
Pipe away condensate with tubing from drain outlet.
Ensure condensate is drained into an oil/water
separator.
•
Fit any further filtration and/or ancillary equipment.
•
Pre-filter is typically supplied with an autodrain installed
in the bowl drain port. On DMC models, this can
be replaced with a solenoid drain valve which is an
optional extra sold separately.
•
It is recommended that a bypass line including XA filter
is installed, as per figure 4.1.
All tubing should be secured up to the point of
drain to prevent whipping during discharge.
Connecting the optional pre-filter drain valve
•
Available on DMC models only.
•
If necessary, remove existing autodrain valve from
pre-filter.
•
Install pipe adapter into pre-filter drain port.
•
Install optional solenoid drain valve onto pipe adapter(s)
taking care to note ow direction as indicated by arrow
etched into the side of the drain valve body.
•
Pipe away condensate with tubing from drain outlet.
Ensure condensate is drained into an oil/water
separator.
All tubing should be secured up to the point of
drain to prevent whipping during discharge.
18
PRODRY PD0046 - PD0360 Instruction Manual
|
Walker Filtration
|
•
•
•
•
•
•
s
.
All tubing should be secured up to the point of drain to
prevent whipping du ring discharge.
Fig ure 4.9 : Conn ecting a pre- filte r
Section 4: Mechanical Installation
•
•
•
.
Available on DMC models only.
• Install optional solenoid drain valve onto pipe adapter(s)
etched into the side of the drain valve body.
•
All tubing should be secured up to the point of drain to
prevent whipping du ring discharge.
Fig ure 4.10 : Conn ecting filte r dr ain
Pipe away condensate with tubing from drain outlet.
Ensure condensate is drained into an oil/water separator.
Figure 4.9: Connecting a pre-filter
18
PRODRY PD0046 - PD0360 Instruction Manual
|
Walker Filtration
|
•
•
•
•
•
•
s
.
All tubing should be secured up to the point of drain to
prevent whipping du ring discharge.
Fig ure 4.9 : Conn ecting a pre- filte r
Section 4: Mechanical Installation
•
•
•
.
Available on DMC models only.
• Install optional solenoid drain valve onto pipe adapter(s)
etched into the side of the drain valve body.
•
All tubing should be secured up to the point of drain to
prevent whipping du ring discharge.
Fig ure 4.10 : Conn ecting filte r dr ain
Pipe away condensate with tubing from drain outlet.
Ensure condensate is drained into an oil/water separator.
Figure 4.10: Connecting filter drain