Page 14
setting up the printer...
The unit has an RS232 printer port located on the rear panel. A ‘receipt’
printer may be attached to this so that a validation report can be printed.
The printer is an optional extra which can be purchased from Walker
Electronics limited.
A special lead is supplied with the printer. It is a grey lead, has a large silver
coloured plug on one end and a smaller black rubber plug on the other.
Attach the large silver plug to the socket underneath the printer and the
other end to the RS232 Printer port on the ultrasonic cleaner. Ensure both
plugs are securely screwed in.
Insert the ribbon cartridge and paper as specified in the operators
handbook supplied with the printer. Attach the power lead and turn on
the power.
Always turn off the power to the printer before turning off the power to the
ultrasonic cleaner.
using a different printer...
If you are using a different printer you will need to know the BAUD rate of
your printer. The printer must have a serial port. The ultrasonic cleaner
must be returned to Walker Electronics Ltd together with the baud rate
setting you require for reprogramming. There is an additional charge for
this service.
printing validation reports...
The unit will store up to the last 100 validated cycles. These can be printed
and stored to form part of the HTM01-05 validation process. The records
can also be downloaded and stored electronically. Please refer to pages16,
17 and 18 for how to do this.
