Walinga AGRI-VAC 5614, Руководство оператора и каталог запасных частей

Страница: 33 / 94

Agri-Vac Operator’s Manual 34-18148-6 31
8. Connect the PTO shaft:
a. Check that the PTO driveline
telescopes easily and that the shield
rotates freely.
b. Attach the driveline to the tractor/power
unit by retracting the locking pin or
pulling back on the lock collar. Slide the
yoke over the shaft and push on the yoke
until the lock pin or lock collar clicks into
position. Be sure the unit is locked in
position.
Fig. 4-9 PTO Shaft Connected.
c. Connect the anchor chains between
the shield on the PTO shaft and the
frame.
d. Lower the shaft storage stand.
Shut off the tractor.
9. Connect the hydraulics.
To connect, proceed as follows:
a. Use a clean cloth or paper towel to
clean the couplers on the ends of the
hoses. Also clean the area around the
couplers on the tractor.
b. Remove the plastic plugs from the
couplers and insert the male ends.
c. Connect the remaining coupler. Be
sure to match the system with the
desired control lever in the tractor.
10. Route the hoses along the hitch and
secure in position to prevent
entanglement with any moving parts.
11. Install safety chains between the
tractor /power unit and the machine
tongue.
12. Raise the hitch jack and rotate it 90° to
place in its stowed position.
13. When unhooking the tractor or power
unit, reverse the above procedure.
Fig. 4-10 Attached To Tractor.