8
8.3
Change batteries
WARNING
Please just use batteries, which comply with the required specifications.
See
Technical Specifications
.
1.
Use a Philips screwdriver to loose the screw on the bottom side of the
transmitter.
2.
Take off the top side of the housing.
3.
Change the battery. Pay attention to the right polarity.
4.
Screw up the housing again.
9.
Accessories and options
You can find extensive accessories for your device in our webshop.
10.
Disposal and environment protection
Your device should be disposed free of charge at the local disposal points.
11.
Technical specifications
Receiver
Power supply
2x1,5 AAA (not included)
Weight
approx. 50g
Dimensions (H x W x L)
approx. 2 x 4 x 7 cm
Sync output
6,3 mm adapter: 3,5mm
Transmitter:
Screw for
opening the
housing
Receiver: Remove
battery cover
5
3.
Overview about the parts
A
Transmitter
B
Receiver
C
Sync Cord Flash
D
3,5 mm Adapter Sync Cord
E
Sync Cord Camera/Transmitter
4.
Quick-start guide
ADVICE:
The detailed instruction for the following operations can be found in the
respective chapters in this instruction manual.
Keep the sequences of the following operation steps when using the device
for the first time to avoid damages on the device.
•
Connect the receiver on the studio flash.
•
Adjust the channel.
•
Connect the transmitter to the camera.
•
Trigger the test button.
5.
Preparation for operation
5.1
Connect the receiver with the studio flash
1.
Switch off studio flash.
2.
Insert the sync cord into the jack of the studio flash.
5.2
Adjust channel
You have the opportunity to operate the Remote Trigger with 4 different
channels. It is important, that you make the same adjustments for
transmitter and receiver as in the following sample.
A
B
E
C
D
