Waldorf RN8510G, Инструкция по установке и эксплуатации

Страница: 25 / 28

23
Gas Conversion and Specifications
Commissioning
Before leaving the installation;
1.
Check all gas connections for leakage using soapy water or other gas detecting equipment.
2. Carry out a ‘Commissioning’ check of appliance as shown in Installation Section of this manual.
3. Ensure any adjustments done to components that have adjustments / settings paint sealed are to be
re-sealed.
Gas Specifications
- Australia / New Zealand Only:
- UK Only:
Appliance Classification
Category:
II
2H3P
(20, 30 / 37).
Flue Type: A
1.
*
- Measure burner operating pressure at manifold test point with two burners operating at full
setting. Operating pressure is ex-factory set, through appliance regulator and is not to be
adjusted, apart from when carrying out Gas Conversion, if required. (Refer to ‘Gas Conversion’
section for details).
D
O NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES
.
Warning
Natural. Gas LP Gas (Propane)
Open Burner
Main Burner Injectors Ø 2.45 mm Ø 1.50 mm
Pilot Burner ('PF' Option Only) 0.30 0.20
Griddle
Main Burner Ø 2.10 mm Ø 1.30 mm
Pilot Burner 0.35 0.23
Main Burner Ø 2.60 mm Ø 1.60 mm
Pilot Burner 0.35 0.23
Low Fire Ø 1.5 mm Ø 0.95 mm
Supply Pressure 1.13 - 3.40 kPa 2.75 - 4.50 kPa
Operating Pressure 0.95 kPa (*) 2.6 kPa (*)
Gas Regulator Cap Screw
Oven
Burner Aeration Setting Fully Open Fully Open
Burner Aeration Setting Fully Open Fully Open
Natural. Gas (G20) Propane (G31)
Open Burner
Main Burner Injectors Ø 2.30 mm Ø 1.40 mm
Pilot Burner ('PF' Models Only) 0.30 0.20
Griddle
Main Burner Ø 2.10 mm Ø 1.30 mm
Pilot Burner 0.35 0.23
Main Burner Ø 2.60 mm Ø 1.60 mm
Pilot Burner 0.35 0.23
Low Fire Ø 1.5 mm Ø 0.95 mm
Supply Pressure 20 mbar 30 / 37 mbar
Operating Pressure 9.5 mbar (*) 26 mbar (*)
Gas Regulator Cap Screw
Oven
Burner Aeration Setting Fully Open Fully Open
Burner Aeration Setting Fully Open Fully Open