16
Cleaning and Maintenance
Main Burners
a. Clean main burners with hot water, a recommended detergent
solution and a scrubbing brush. Ensure any excess water is
removed from inside the burners. Dry all burners thoroughly
with a dry cloth.
b. Ensure burners are fitted correctly over main injectors and are
located properly into recesses in chargrill.
Stainless Steel Surfaces
a. Clean exterior surfaces of chargrill with hot water, a mild
detergent solution and a soft scrubbing brush. Note that gas
control knobs are a push fit onto gas control valve spindles and
can be removed to clean control panel.
b. Baked on deposits or discolouration may require a good quality
stainless steel cleaner or stainless steel wool. Always apply
cleaner when appliance is cold and rub in direction of the grain.
c. Dry grease tray thoroughly with a dry cloth.
d. Dry all components thoroughly with a dry cloth and polish with
a soft dry cloth.
Periodic Maintenance
NOTE: All maintenance operations should only be carried out by a qualified service person.
To achieve the best results cleaning must be regular and thorough and all controls and mechanical parts
checked and adjusted periodically by a competent serviceman. If any small faults occur, have them
attended to promptly. Don't wait until they cause a complete breakdown. It is recommended that the
appliance is serviced every 6 months.
Gas Control Valve Re-Greasing
Gas control valve should be dismantled and greased every 6 months to ensure correct operation.
To carry out this operation;-
a. Remove gas control knobs from gas tap spindles.
b. Remove drip tray from appliance.
c. Remove two screws on underside of control panel, securing
control panel to hob.
d. Remove control panel from front of appliance.
e. Remove 2 screws holding shaft plate to gas control body and
remove control shaft and plate.
(See Fig 11).
Note orientation
of shaft for correct re-assembly.
f. Using needle nose pliers or similar, pull out gas control
spindle, again noting its orientation.
g. Apply a suitable high temperature gas cock grease or
lubricant such as ROCOL - A.S.P (Anti scuffing paste)/
Dry Moly Paste to outside of spindle.
(See Fig 12).
h. Replace spindle and re-assemble gas control in reverse
order.
i. Refit control panel to appliance and secure with 2
screws.
j. Refit knobs to gas control valve spindles.
Fig 10
Two Screws
Fig 11
Spindle
Fig 12
Fig 9
