Waldmann ZAPP!, Инструкция по эксплуатации

Страница: 22 / 44

22
Product description
ENG
4.1 Inserting the lamp
CAUTION
Risk of injury due to lamp breakage.
If the lamp is not installed properly, it
may break and cause injury.
X
Wear protective gloves.
1. Unscrew the round lamp cover on the
side with the yellow safety label.
2. Unscrew the two spacer bolts A , see
Fig. 1.
3. Remove the filter ring B , see Fig. 1.
4. Pull off the black cover cap C , see Fig. 2.
5. Slide the new lamp into the guide.
6. Hold the lamp base D and put the lamp
socket E onto the lamp base, see Fig. 3.
7. Slide the cover cap over the lamp
socket.
8. Put the filter ring on the screw bolts.
9. Fix the filter ring with the spacer bolts.
10. Screw the lamp cover onto the spacer
bolts.
4.2 Assembly
Disassembling the stand holder
Fig. 4: View upon delivery.
NOTE: On delivery, both the stand
holder F and the wall mount G are
assembled to the device, see Fig. 4
and see Fig. 5.
G
F
Fig. 5: Loosen the screws.
1. Loosen both screws and remove the
stand holder
F
from the fixture, see
Fig. 5.
2. The next steps depend on how you
want to use the device:
ƒ
Wall-mounted device, see Section
“Assembling the wall mount”, page
23
or
ƒ
Standing device, see Section
“Assembling the stand holder”, page
23.