45
Configuringthe swarm control
ENG
7.3 Configuring the
swarm control | On the mod-
ule
X
Plan which area and which groups the
luminaire should be affected to.
Fig. 52: "area" rotary coding switch
X
Set both "area" rotary coding switches
to the desired area address, see Fig. 52.
Fig. 53: "group1" and "group2" rotary cod-
ing switches
X
If you want to assign the luminaire to
exactly one group, both rotary coding
switches "group1" and "group2" should
be set to the same group address, see
X
If you want to assign the luminaire
exactly to two different groups, the
"group1" and "group2" rotary coding
switches must be set to the relevant
group addresses.
Fig. 54: Swarm control activated.
X
Slide the "mode" slide switch to posi-
tion
1
Once the module has been connected,
all luminaires to which a module has
been connected will communicate with
each other.
After no later than 15 minutes, the auto-
matic teach-in process will be com-
plete, updating taking place at regular
intervals.
