500.0022-A
5
Subject to technical changes
Locking the safe
1.
Close the door (rotary opening handle in
"open" position).
2.
Turn the rotary opening handle
counterclockwise into the "closed"
position (lock closes automatically).
3.
Gently press the rotary opening handle
clockwise to check whether the lock
–
and therefore the safe
–
are locked.
Reprogramming codes
NOTE:
A new code must always be programmed while the door is open so that the safe is
not closed in case of an incorrect input, which would result in an incorrect code being
programmed!
If the code has been forgotten or can no longer be reconstructed, an emergency opening
of the safe must be performed and it must be repaired or replaced at the owner's expense!
The certification lapses in case of a repair.
Procedure:
1.
Open the door with the current code.
2.
Leave the rotary opening handle in the "open" position.
3.
On the input unit, press the Mode key; the display shows: PRG-MOD.
4.
Enter the existing master code, confirm with the Enter key, and the display will show
TIME.
5.
Press the arrow key until CODE appears, and confirm with the Enter key.
6.
The display shows MASTER; confirm with the Enter key, and the display shows:
CHANGE? YES; also confirm with the Enter key.
7.
Input the new master code 00 X X X X X X and confirm with the Enter key; the display
shows CONFIRM.
8.
You must enter the new code again to confirm it, and acknowledge with the Enter key.
The display now shows ACCEPT.
