![background image](http://html1.mh-extra.com/html/waldbeck/10030404/10030404_manual_3170089012.webp)
Step 5
Mount a washer, followed by a wheel
(with valve stem facing out), onto each
end of the front axle. Slide another wash-
er onto each end of the axle followed by
a cotter pin (flg 3).
Note: Axle sleeves are not used on the
front axle.
Step 6
Remove the 8mm nut and washer, and
large washer from the pre-welded bolt on
the front axle support. Place the handle
over the pre-welded bolt and secure with
the large washer, small washer and nut
as shown (Fig.: 1a). Hand tighten.
Important:Do not over-tighten bolts on
the steeringmechanism or the steering
may „freeze up.“
Pull the tractor scoot to make sure the
handle moves freely left and right. If the
handle does not steer well or seems stiff,
you may need to slightly loosen one or
both of the nuts on the handle.
Step 7
Using the small 6xl5 mm bolts, nuts and
washers, attach the tray (front first) to
the frame using the small reinforcing
plate. Place the plate under the front
rim of the tray lining up the holes with
the pre-drilled holes in the (pre-welded)
front tray bracket (Figure 4). (It helps to
rest the back of the Tray on the back tires
(or support while lining up the parts in
the front.) Hold each nut with a wrench
or pliers while tightening each bolt with a
flat head (slotted) screwdriver.
Step 8
Repeat Step 6 to attach the back of the
tray using the scoot tray bracket and
small reinforcing plate. Fully tighten all
nuts on the tray.
12
Содержание 10030404
Страница 1: ...10030404 Fahrbarer Arbeitsstuhl...
Страница 3: ...Teileliste 3...
Страница 9: ...Parts List 9...