At the completion of washing
1.
Open
the milk line valve/s.
2.
Close
the valve at the wash tub.
3. Turn
off
the air injector/s.
4.
Close
the air injector valve/s.
5.
Close
the snap clamp on the rubber tube connecting the sanitary trap to the
receiver suction line.
6.
Slowly pull the plug out of the interceptor to lower the vacuum.
7. Turn
off
the vacuum pump/s.
8.
Remove the clusters from the cluster washers.
The minimum wash water requirements for your
Waikato
Rotary Loopline
are:
Hot Water:
10 litres per cluster
Cold Water:
15 litres per cluster
Waikato Milking Systems recommend that you wash your
Waikato
Rotary Loopline
with hot water after each milking. You should use only approved detergents and follow
the detergent manufacturers’ instructions.
Your Waikato Milking Systems dealer will set up your washing system and run through it
with you so that you fully understand its operation.
4
