www.wahsega.com
Page 27
Option A
– Steps for activating a partial factory reset:
1.
Start with the PoE cable plugged in and the speaker powered
on
.
2.
Find the green status LED on the face of the speaker. Next to the
status LED, locate the small, black reset button.
3.
Press and hold the reset button until the status LED begins to blink.
(If the status light does not begin to blink, reposition and try again.)
4.
Once the status light begins to blink, release the button, and the LED
should return to a solid green.
5.
You have successfully reset your ceiling speaker’s IP address to its
default DHCP address. You will need to use this new, dynamic IP
address to access your speaker’s configuration webpages again.
Option B
–
Steps for activating a full factory reset:
1.
Start with the PoE cable unplugged and the speaker powered
off
.
2.
Plug in the PoE cable and apply power to your ceiling speaker. As
soon as power is applied, hold the reset button as the status light
begins to blink.
3.
Once the status light starts to blink, continue to hold the button for
at least five (5) seconds.
4.
After 5 seconds, the status light will flash more slowly, indicating that
the file system has been reformatted and all data has been erased
from the device.
5.
Unplug and restart your speaker for the new settings to take effect.
6.
If you have previously changed the IP address of your ceiling speaker
to a static IP address, keep in mind that restoring factory default
settings will return your speaker to dynamic IP (DHCP) mode. You
will need to use the new, dynamic IP address to gain access to your
speaker’s configuration webpages once again.
7.
You have successfully reset your configuration!
