320.805.004
12
Date: 2022-02-09
Model-1 Opti&Mini
NONAME-1
Check your situation.
ready to transmit?
Yes
No
Using the remote
WARNING! Make sure the Right Gimbal J1/J2 is in the centre position before turning ON the
platform.
For using the remote RadioLink AT9S Pro see page 16.
The remote and the platform has been paired together at the manufacturing facility and the
product is ready for use. For guidance on changing the maximum speed and acceleration
/deceleration ramp see page 13.
The unit has a lot of controls not being used for this application and these may be left is any
position, meaning that this will not affect the behaviour of the platform when using the factory
defaults explained in this manual, the below
Figure 2
will identify the specific controls needed
for operation.
Figure 2: Flash 7 Remote (Flash 8)
Power on
Power on the remote using the [On/Off Switch] and turn down the left throttle joystick [Left
Gimbal J3/J4] and the display will show.
Use the [Jog Dial] to select [Yes] if not already highlighted and then press Enter [Jog Dial] when
you are ready to continue.
T1/T2
