Wahlberg 255.700, Руководство пользователя

Страница: 8 / 40

255.805.001 8 Date: 2021-03-12
Physical installation
WARNING! The product must be either fastened to a flat surface such as a roof or clamped to
a truss or similar structure. Do not apply power if it is not securely fastened.
WARNING! The supporting surface must be hard and flat. Fasten the product securely.
WARNING! When the unit is installed in a location where it may cause injury or damage if it
falls, install a secondary suspension such a BGV C1/DGUV 17 safety cable using one of the
12.5mm (0.49 in) holes and fasten it securely around the truss/pipe.
Fastening the product to a flat surface
The product can be fastened to flat surface such as a roof. Check that the surface can support at
least 10 times the weight of all products and equipment to be installed on it, and that the
installation respects all locally applicable regulations.
Mounting the product on a truss (tube/pipe)
The unit can be clamped to a truss or similar rigging structure.
To clamp a product to a truss (tube/pipe):
1. Check that the rigging clamp is undamaged and that the rigging structure can support at
least 10 times the combined weight of all products and equipment to be installed on it.
2. Use the suitable rigging clamp or contact Wahlberg Motion Design for a replacement.
3. Fasten the clamp to the unit with the supplied M12 bolts, nuts, and washers in the hole of
the mounting clamp on the unit.
4. Block access under the work area. Working from a stable platform, hang the product on
the truss with the fabric downwards. Tighten the rigging clamp.
5. Install a suitable safety cable when the product is hanging over-head.
Safety Cable
Half-coupler