8
EN
For easy cleaning, you may rinse your shaver with water. While the foils can be rinsed,
we recommed removing the foil head, and rinsing the cutter bars. This will allow any
hairs still on the cutter bars to be washed away. Leaving the foil head on while rinsing
makes it more difficult for hairs to be washed clean.
TO REMOVE CUTTER BAR (E)
Turn shaver off. Remove the foil head and, holding the shaver in one hand, gently pull up
on cutter bar. Be sure your thumb and first finger are positioned at each end of the cutter
bar.
WARNING: Handle cutting components with care to avoid personal
injury.
NOTE: If you do not hold the cutter bar as shown, brushing the blades could result in
damage to the assembly.
When the foil head and cutter bars are removed from the shaver, an alternate cleaning
method is to rinse them under running water. Simply let them air dry.
After cleaning, replace the cutter bars by pressing down gently. Carefully replace the foil
head, snapping it into place.
From time to time, depending on the density of your beard, you will need to replace the
cutters and foils. If you notice that it is taking you longer to shave, or if your face starts to
feel some irritation, or if the foil seems to become warm to the touch, it is probably time
to replace the cutters and foils. Replace the cutters and foils only with WAHL parts
(Yellow: 7045-100, Silver: 7045-400, Black Chrome: 7045-700).
FOIL & BLADE CARE
Trimmer blades have precision-hardened, ground and lapped cutting teeth. Foils, cutter
bar, and blades should be handled carefully and never bumped or used to cut dirty or
abrasive material.
OILING THE FOILS & CUTTER BAR
Oil lubrication helps maintain smooth blade movement and shaving performance.If the
shaver is regularly cleaned under water. The Foils should be oiled at least once per
week.Use clipper oil or shaver oil.
Instructions: When foils and blades are clean and dry, apply a drop of oil to the top of
each foil and on top of the center cutter bar. Use finger to gently spread the oil over the
surface. Turn the shaver on for 10 seconds to help distribute the oil onto the blades
below. Turn off shaver and use a tissue or soft cloth to wipe any excess oil from the sur-
face.
CLEANING & OILING TRIMMER BLADES
Clean with the included brush. For best results, put one or two drops of Wahl Clipper Oil
on
the blades only when necessary, or approximately once a month. Motor bearings are
permanently lubricated—do not attempt to oil.
When oiling your trimmer, turn the trimmer “ON - I,” hold the unit with the blades facing
DOWN and squeeze one or two drops of oil onto the blades. Wipe off excess oil with soft
cloth.
STORAGE
Before storing your trimmer, use the cleaning brush to whisk any loose hairs from the
unit, foils, cutter bar, and blades. Store unit in such a manner so that blades are protect-
ed from damage.
When the shaver is not in use, the shaver foil/blade guard attachment should be in place
to protect the blades.
This appliance should be stored in a manner where it is not subjected to Crushing,
91590-400.indd 8
7/2/18 5:55 PM
