WAGO Pro 2, Руководство по эксплуатации продукта

Страница: 67 / 78

2787-2146 (/0000-00x0) Notes on Operation
Product manual | Version: 1.2.2 67
Power Supply Pro 2
• Digital input
t
I
ECB
t
ECB
t
0
t
1
<100ms
I
OUT
/ I
N
Figure 42: “Electronic Circuit Breaker” Mode
11.6.5 “Latching Shutdown on Thermal Overload” Mode
In this mode, the output voltage is switched off in the event of excessive internal device
temperature. A corresponding “High Device Temperature” warning can, for example, be
transmitted via the WAGO Interface Configuration software or passed to a higher-level
controller via a connected
8
communication module [
}
72] . To switch the output back
on, manual intervention is necessary. The following options are available for this:
• Communication interface
• Buttons
• Digital input
11.6.6 “Power Boost” Mode
This mode can be used in combination with the following modes:
•
8
“Constant Current” Mode [
}
65]
• 8 “Constant Current with Latching Shutdown” Mode [ } 65]
•
8
“Electronic Circuit Breaker” Mode [
}
66]
In this mode, output current equal to 150 % of the nominal output current is permitted for
5 seconds. The output is then switched off. To switch the output back on, manual inter-
vention is necessary. The following options are available for this:
• Communication interface
• Buttons
• Digital input
In combination with the
8
“Constant Current” Mode [
}
65] , the “Power Boost” Mode is
activated again after each pause.