18
Device Description
WAGO-I/O-SYSTEM 750
753-646 KNX/EIB/TP1 Module
Manual
Version 1.1.0
Pos : 29 /All e Seri en (Allgemei ne Module)/Ü berschrif ten f ür alle Serien/G erätebesc hreibung/Bedienel ement e - Ü berschrif t 2 @ 4\ mod_1239191655456_21. doc x @ 30439 @ 2 @ 1
3.4
Operating Elements
Pos : 30 /Serie 753 ( WAGO-I/ O-SYST EM)/ Ger ät ebesc hrei bung/Bedienel emente/ Bus klemmen/Bedienelemente 753- 0646 @ 5\ mod_1254117851375_21. doc x @ 42200 @ @ 1
The I/O module has two programming button connections (see figure below) for
parameterization of the KNX module in the device mode.
Figure 4: Programming button
Actuation of the buttons is requested by the engineering tool software (ETS)
during startup of the module.
A temporary electrical connection is established between these two programming
button connectors (2 and 6), via a wire jumper for example, which activates the
programming mode.
Pos : 31 /D okument ation allgemei n/ Glieder ungs elemente/---Seit enwechs el--- @ 3\ mod_1221108045078_0. doc x @ 21810 @ @ 1
