852-111/000-001
Safety
Product manual | Version: 1.0.1
9
Industrial-Eco-Switch
Shielding/Network
Radio, etc.
• This is a Class A product. The product can cause radio interference in residential ar-
eas; in this case, the operator can be required to take appropriate measures to prevent
such interference.
• For industrial use: WAGO's 852 Series ETHERNET Switches are certified to be used
in residential and in industrial environments. If the latter, they should be considered as
exposed operating components. Therefore, in industrial applications, only install these
switches in lockable housings, cabinets or electrical operation rooms. Access must be
limited to authorized, qualified staff having the appropriate key or tool.
• Only use devices equipped with ETHERNET or RJ-45 connectors in LANs. Never con-
nect these devices with telecommunication networks.
Components
• Replace defective or damaged device/module (e.g., in the event of deformed contacts).
2.3 Mechanical Safety
• Observe possible different technical specifications for mounting that does not corre-
spond to the specified mounting position.
• Before startup, please check the product for any damage that may have occurred dur-
ing shipping. Do not put the product into operation in the event of mechanical damage.
• Only use this product in a controlled environment.
• Do not open the product housing.
• Avoid conductive contamination.
2.4 Thermal Safety
• The surface of the housing heats up during operation. Under special conditions (e.g., in
the event of a fault or increased surrounding air temperature), touching the product
may cause burns. Allow the product to cool down before touching it.
• If the surface temperature of the product can exceed 40 °C, wear protective gloves and
attach protective covers and/or touch-proof protection.
• The temperature inside the additional enclosure must not exceed the surrounding air
temperature permitted for the mounted product.
• Cooling of the product must not be impaired. Ensure air can flow freely and that the
minimum clearances from adjacent products/areas are maintained.
2.5 Indirect Safety
• Do not use hard objects that could cause scratches for cleaning.
• Do not use any contact spray for cleaning.
• Clean tools and materials are imperative for handling the product.
• The products are not resistant to materials having seeping and insulating properties
such as aerosols, silicones and triglycerides (found in some hand creams). If these
substances occur in the environment of the products, install the products in an addi-
tional housing that is also resistant to these substances.
