WAGNER Wildcat 18-40, Перевод оригинального руководства по эксплуатации

Страница: 32 / 80

32
Wildcat & Puma 40 cm 3
B_05443
OPERATING MANUAL
VERSION 05/2015 ORDER NUMBER DOC2303659
Procedure:
1. Ground the pump, connect the grounding cable to
potential equalization on-site.
2. Ground the product tank.
3. Ground the other parts of the system to an on-site
grounding connection. 16 mm2;
Ex zone
All devices and equipment must be suitable for use in potentially
explosive areas.
6.6
COMMISSIONING
Observe all safety regulations in accordance with Chapter 4 and Chapter 7.2.
Emergency stop, see Chapter 7.3.
Preparation
Before every start-up, the following points should be observed as laid down in the
operating manual:
- Secure gun with safety clip.
- Check the permissible pressures.
- Check all connecting parts for leaks.
- Check hoses for damage in accordance with Chapter 8.2.9.
Fill the pump with fl ushing agent
The devices are tested during manufacturing with emulsifying oil, pure oil or solvent.
Possible residues must be fl ushed out of the circuits with a solvent (fl ushing agent) before
commissioning.
- Fill the separating agent in accordance with Chapter 8.2.4.
- Fill the empty device with fl ushing agent in accordance with Chapter 8.2.7.
Pressure tightness test
- Gradually increase the pressure in pump with the pressure regulator until maximum
pressure is reached. Maintain the pressure for 3 minutes and check all connection
points for leaks.
- Depressurization in accordance with Chapter 7.5.
Filling with working material
- In accordance with Chapter 7.6.1.
Safe operation of the IceBreaker pump is only guaranteed with a grounding
connection.
Connect all ground cables using a short and direct route.
Tank
All paints, fl ushing agents and waste tanks have to be electrically conductive.
All tanks must be grounded.