WAGNER W 860 E, Инструкция по эксплуатации

Страница: 29 / 56

GB
23
W 860 E
Correction of Malfunctions
Malfunction Cause Remedy
No coating material
emerges from the
nozzle
Nozzle clogged
Material volume setting turned too far
to the left (-)
No pressure build-up in container
Container empty
Feed tube loose
Feed tube clogged
Clean
Turn to the right (+)
Tighten container
Refill
Insert
Clean
Coating material drips
from the nozzle
Coating material assembly at air cap,
nozzle or needle
Nozzle loose
Nozzle seal worn
Nozzle worn
Clean
Union nut tighten
Change
Change
Atomisation too coarse Material volume too large
Material volume adjusting screw turned
too far to the right (+)
Nozzle contaminated
Viscosity of coating material too high
Too little pressure build-up in container
Air filter heavily soiled
Amount of air too low
Turn material volume adjusting
screw to the left (-)
Clean
Add 5 - 10% dilution
Tighten container
Change
Turn the air volume control to
the right (+)
Spray jet pulsates Coating material in container running
out
Nozzle seal worn
Air filter heavily soiled
Refill
Replace
Change
Coating material causes
"paint tears"
Too much coating material applied. Turn material volume adjusting
screw to the left (-)
Too much fog of
coating material
(Overspray)
Distance to the object too large
Too much coating material applied
Amount of air too high
Reduce distance
Turn material volume adjusting
screw to the left (-)
Turn the air volume control to
the left (-)
Paint in the ventilating
hose
Diaphragm soiled
Diaphragm defective
Clean the diaphragm
Replace the diaphragm
Device does not
function
Device overheated Unplug the power plug, let
the device cool down approx.
30 minutes, do not bend the
hose, check the air filter, do not
cover the intake slots
Stör GB