5
English
Practice /
Usage
Start
IMPORTANT:
Make sure your floors and furnishings are
covered with drop cloths during usage.
Handle Button:
When the handle button is pressed and
released, the pump motor will switch on and
material will begin flowing into the paint hose.
To shut the motor off and stop the flow of
material, press and release the handle button
again.
Note:
Make sure to fully press and release
the handle button. If the handle button is only
partially pressed, the motor will start, but will
shut down again after the button is released.
IMPORTANT: Do not submerge handle
into any liquids, and avoid getting any
spillage around the handle button.
Variable Speed Dial:
The settings on the variable speed dial
determine the flow rate of paint (1-9). The
higher the setting, the higher the flow rate.
A setting of zero (0) means the unit is
switched OFF.
Variable Speed
0
9
1.
If using the 9” roller
, set the
variable speed dial to 9.
4. To start the motor, fully press
and release the handle button.
When paint starts to show
through the roller, press and
release the handle button to
shut off the motor.
2.
If using the Smart Edge
Roller
, set the variable speed
dial to a lower setting (1-2).
Tips:
• Practice rolling on a scrap
piece of wood or cardboard.
• Press the handle button to
start and stop the pump as
needed.
• Adjust the variable speed
dial as needed to maintain
the desired material flow.
See Helpful Painting Tips,
next page, for more detailed
preparation and rolling
instructions.
3. Make sure the paint flow direction
switch is set to “PAINT” position.
9
1
2
9
1
2
4
2
3
PAINT
1
9”
3”
