English
12
Spraying
Troubleshooting -
Clear the
Spray Tip
Start
You will need:
• Scrap material / cardboard
Do not attempt to unclog or
clean the tip with your finger.
High pressure fluid can cause
injection injury.
1. Lock the spray gun.
2. Rotate reversible spray tip 180 degrees
to
ClEan
position (arrow pointing
toward the rear of the spray gun).
note:
If spray tip is difficult
to rotate, relieve pressure
by
1)
slowly turn PRIME/
SPRAY knob to PRIME,
2)
unlock the spray gun and
3)
squeeze trigger while
pointing at scrap material/
cardboard. Release
trigger, lock the spray gun,
and try rotating spray tip
again.
3. Make sure the PRIME/SPRAY
knob is turned to SPRAY -
MINIMUM PRESSURE.
Unlock the spray gun.
4. Point at a piece of scrap material / card-
board and squeeze trigger until material
comes out in a high pressure stream.
Release the trigger and lock the spray
gun.
5. Reverse the spray tip so
the arrow points forward.
Unlock the spray gun and
resume spraying.
1
2
3
4
5
