WAGNER PEM-TG3, Руководство по эксплуатации

Страница: 14 / 32

Working with the spray gun
14
0351717
- PEM-TG3
04/2006
J
5
6
3
H
2
4
1
Pemtg3_0005a
K L
Pemtg3_0001b
•
Unsc
adap rew the powder cup H from the
ter J .
•
With the black setting knob L open the
Tribo air all the way and with the red
•
Set the overall air quantity to the
maximum with knob
22 .
•
Hold the spray gun in the coating
booth, actuate the spray gun trigger
and remove any residual powder
inside the spray gun.
•
Switch the control unit off and secure
it against being unintentionally
switched on again.
ousing 5 .
body 3 off the
setting knob K open the feed air all the
way.
•
Pull the deflector cone 1 off the
charging body 4 .
•
Unscrew the outer nut 2 from the
spray gun h
•
Carefully pull the nozzle
powder tube
6 .
•
Carefully pull the charging body 4 out
of the powder tube 6 .
Caution
When pulling , ensure that the charging body is not
damaged!
out and inserting the parts
•
Remove powder residue from the parts removed, from the spray gun and the powder
container.
•
Mount the cleaned or a new powder container.
•
Carefully push the charging body 4 into the powder tube 6 .
•
Push the nozzle body 3 over the powder tube 6 and tighten using the outer nut 2 .
•
Slide the deflector cone 1 back over the charging body 4 .
Activate the spray guns in accordance with chapter:
"
g up the spray gun and adjusting Tribo air
•
Startin ".