© 2003 Wagner Spray Tech - All rights reserved.
9
Customer Service: 800-328-8251
English
C
LEANUP
P
URGING THE
P
AINT
H
OSE
1. Lock the gun, remove spray tip
assembly, and turn the
PRIME/SPRAY knob to PRIME.
2. Dump out any remaining spray material
from the hopper back into its container
(see
Emptying the Hopper,
page 5).
3. Fill the hopper with the appropriate
cleaning solution.
4. Hold the spray gun against the side of
the paint can and hold the trigger.
5. While holding the trigger, turn the
pump ON, and turn the
PRIME/SPRAY knob to SPRAY.
6. Release the trigger and turn the
PRIME/SPRAY knob to PRIME.
7. Hold the spray gun against the side of a
separate container
and hold the trigger.
8. Turn the PRIME/SPRAY knob to
SPRAY and trigger the gun until the
fluid coming out of the gun is clear.
9. Turn the PRIME/SPRAY knob to
PRIME and trigger gun once more to
relieve pressure.
10. Move on to
Rinsing the Hopper.
You might need to add more cleaning
solution to the hopper.
Let the pump run until all paint is
purged from the hose and cleaning
solution is coming out of the gun.
SPRAY
PRIME
l
SPR
A
Y
PRIME
These steps will allow you to recover
excess paint left over in the paint hose.
R
INSING THE
H
OPPER
1. Thoroughly rinse out the hopper
using the appropriate cleaning
solution.
2. Remove the inlet filter from the
bottom of the hopper and clean. You
may need to use a screwdriver to pry
the filter loose.
3. Replace the filter and properly
dispose of the cleaning solution.
F
LUSHING THE
S
PRAYER
1. Fill the hopper with
NEW
cleaning
solution.
2. Turn the PRIME/SPRAY knob to
PRIME, turn the pump to ON .
3. Let the pump circulate the cleaning
solution out the return tube for 2-3
minutes.
4. Turn the pump OFF .
5. Properly dispose of cleaning solution
and move on to
Cleaning the Spray
Gun Components
,
next page
.
O
l
SPR
A
Y
PRIME
Inlet
filter
Make sure you do not drip any cleaning
solution into the motor housing.
I
MPORTANT
C
LEANING
N
OTES
!
R
EAD
T
HESE
N
OTES AND
W
ARNINGS
B
EFORE
Y
OU
S
TART TO
C
LEAN
Y
OUR
S
PRAYER
!
• When using latex paints, clean
your sprayer and components
using warm, soapy water.
When using oil-based paints,
use mineral spirits.
• Do not use mineral spirits on
latex paint, or the mixture will
turn into a jelly-like substance
which is difficult to remove.
• No matter which cleaning
solution you use, make sure to
dispose of it properly when
finished cleaning your sprayer.
• Thorough cleaning and
lubrication of the sprayer is
the most important step you
can take to ensure proper
operation after storage.
CALL
1-800-328-8251
IF YOU HAVE ANY QUESTIONS
REGARDING THE CLEANUP OF
YOUR SPRAYER
Special cleanup instructions for use with
flammable solvents:
•
ALWAYS FLUSH SPRAY GUN AT
LEAST ONE HOSE LENGTH
AWAY FROM SPRAY PUMP.
• If collecting flushed solvents in
one gallon metal container, place
it into an empty five gallon
container, then flush.
• Area must be free from vapors.
• Follow all cleanup instructions.
• NEVER USE GASOLINE TO
CLEAN THE SPRAYER!
WARNING
