Power Dome 400W
6
USER’S MANUAL - Please read before using this equipment.
7
DC TO AC POWER INVERTER
The Power Dome’s inverter can operate most AC appliances or a combination of appliances
up to 400 watts. Operating time is dependant on the AC load (watts) and the charge and
condition of Power Dome’s internal battery. Reduced AC loads and full charge on the battery
will result in longer operating time. Be sure to turn off or disconnect any AC appliance not
in use.
There is a user replaceable 40 amp automotive type fuse to the left of the inverter
ON/OFF
Switch. This fuse protects the inverter from an unlikely excessive input current. Ordinary
overloads will cause the inverter to automatically shut down. Reduce the load and restart
the inverter.
USING THE POWER INVERTER
1. Open the AC outlet dust cover.
2. Connect the AC appliance or appliances to either AC outlet.
3. Turn on the Inverter using the Inverter’s ON/OFF switch.
4. If the Inverter Power Indicator LED lights green, the inverter is operating.
5. Turn on one AC appliance and observe the Power Indicator.
6. If the LED remains green, then turn on the second appliance.
7. If the Power Indicator remains green, then both appliances are operating properly.
8. After use, remove the appliance plug and close the dust cover.
9. Recharge Power Dome as soon as convenient.
NOTES:
If the Power indicator LED is not lit, then reduce the AC load. If the inverter is
still not operating, refer to the troubleshooting table at the end of this User’s Manual.
CAUTION:
Some rechargeable devices are equipped with a separate AC charger. These devices will
likely operate properly with this inverter. Rechargeable devices that have built-in chargers
(see device owner’s manual), may not be operate properly with this type of inverter.
The motors of some motorized devices may operate at excessive motor temperature.
Abnormally elevated temperature of the motor is an indication that they should not be used
with this inverter.
Some Televisions and other electronics with sensitive components should be checked to see
if they are compatible with modified sine wave (non-sinusoidal) inverters. Check with the
appliance manufacturer.
6. Move the nozzle lever Down to secure the nozzle to the valve stem.
7. Turn compressor switch on to ON position.
8. Monitor the pressure gauge while inflating the tire.
9. When recommended tire pressure has been reached, turn the Compressor OFF.
10. Disconnect hose and replace valve cap.
11. Store the hose in the Air hose Compartment
12. Recharge the Power Dome as soon as convenient.
Figure 2 POWER DOME Rear View
This figure shows the Fuse, Power Inverter’s ON/OFF Switch, two AC Outlets, Jumper
Safety Switch and the Compressor Hose Compartment.
(fig.2)
