WAERATOR W2, Руководство пользователя

Страница: 9 / 16

WAERATOR
TM
Instant Wine Aerator W2 User Manual 7
Section 4
Cleaning the Waerator
It is highly recommended that you run clean water through the Waerator before using it in order to clear out any
dust or debris that may have settled inside the spout or nozzle during shipping.
Step 1. Remove the cover, place 4x AAA batteries into the battery compartment.
Step 2. Replace the cover then take an empty wine bottle and fill it with clean water.
Step 3. Connect the tube to the Waerator by pressing the end with the cap onto the nozzle.
Step 4.
Place the Waerator over the mouth of the bottle making sure to thread the tube though the neck.
Step 5. Place a glass or other container under the Waerator’s spout.
Step 6. Press and hold the button to use the Waerator. Continue until all the water has been used up.
Step 7. Repeat this process at least 3 times to fully clean out the Waerator.
• Use a dry, non-abrasive cloth to gently remove debris and/or wipe the outside of the aerator.
• Never spray liquid directly onto any part of the aerator. Only wine, beer, whiskey, scotch, and water may come in
direct contact with the tubes, nozzle, and injection openings.
• After cleaning the aerator, allow 24 hrs drying time. Check all parts before reinstalling.
• Never use cleaning solutions. Only water may be used during cleaning.
• Do not expose the aerator’s internal electric components to water, moisture, or liquids. If water enters the
electric parts of the aerator, these components may sustain serious internal damage.