Waeco PerfectView VT100WiFi, Руководство по установке и эксплуатации

Страница: 24 / 200

Connecting the transmitter electrically VT100WiFi
EN
24
Attaching the transmitter (fig. 5 1, page 5)
To perform the installation, proceed as follows:
➤
Hold the transmitter at its installation location and mark the four points for the drill
holes.
➤
Drill the holes, with a Ø of 4 mm, at each of the markings.
➤
Screw the transmitter on using M5 x 20 mm self-tapping screws.
Fixing the antenna (fig. 5 2, page 5)
To perform the installation, proceed as follows:
➤ Remove the plastic film from the antenna.
➤
Stick the antenna to the selected installation location.
7 Connecting the transmitter electrically
7.1 General notes on laying cables
I
Therefore, please observe the following instructions:
 Wherever possible, lay cables inside the vehicle, as they are better protected there
than outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use
additional cable ties, insulating tape etc.).
 To prevent damage to the cables when laying them, ensure that they are far enough
away from hot or moving vehicle components (exhaust pipes, drive shafts, light
systems, fans, heaters, etc.).
 Screw on the plug connections for the connecting cables to protect them against water
penetration (fig.
6 , page 5).
NOTE
 As far as possible, use original ducts for laying the cables, or other suitable
options such as panelling edges, ventilation grilles or dummy plugs.
If no openings are available, you must drill holes for the cables. Check
beforehand that there is sufficient space on the other side for the drill head
to emerge.

Cables and connections that are not properly installed will cause malfunc-
tions or damage to components. Correct installation of cables and
connections ensures lasting and trouble-free operation of the retrofitted
components.