Waeco PerfectView VT100WiFi, Руководство по установке и эксплуатации

Страница: 23 / 200

VT100WiFi Installing the transmitter
EN
23
6.2 Preparing the transmitter for installation
!
Observe the following installation instructions:
 Install the transmitter so that as few objects as possible are situated between the trans-
mitter and receiving device. Moving the antenna can help if there is a poor connection.

If possible, install the transmitter in the vehicle.
The housing is splash-water protected and can be mounted outside on the vehicle.
Nevertheless, you should select a place that is well-protected. Select a place that is
protected against mechanical impact (e.g. flying stones) if you install the transmitter
on the outside of the vehicle.
 The installation location should be flat.
 Before drilling each hole, ensure there is sufficient space on the other side for the drill
head to emerge (fig.
4 , page 5).
 Make sure you can lay the connection cable from the transmitter to the camera.
I
To perform the installation, proceed as follows:
➤
Attach the transmitter and the antenna in the installation location provisionally.
➤
Install the camera.
➤
Start the transmitter and put your receiver in the selected position (e.g. driver's cab)
and activate the app, see chapter “Using the transmitter and the app” on page 26
If the camera image is transmitted steadily (no flickering), you can install the
transmitter permanently.
If there is interference, such as flickering images, turn or move the antenna slightly
and test the transmission again.
CAUTION!
Select the place of installation for the transmitter so that it is not able to injure
any vehicle passengers at all (e.g. from braking suddenly or car accident).
NOTE
The image is sent from the transmitter to the receiving device. To ensure
flawless functioning, you need to check whether the wireless transmission is
stable before final installation.