Waeco PerfectView CAM604, Инструкция по установке и эксплуатации

Страница: 38 / 260

EN
Fitting the camera PerfectView CAM604
38
8.4 Connecting the connection box (fig. l , page 9)
The control box is supplied ready for installation.
➤
Fasten the control box at a suitable point.
I
➤
Connect the control box electrically as follows:
– Connect the camera inputs on the monitor to the “C1” and “C2”
connections.
– Connect the system cable from the camera to the “CAM” connection.
The camera is switched on and off in reverse gear or using the camera selec-
tion button on the monitor.
8.5 Checking the function and setting the camera
➤
Check the function of the camera after you have connected it to a monitor.
You can switch between the close-up and long-distance range of the camera
by switching between the camera inputs on the display device.
➤
Align the camera using the image on the monitor to help you:
The monitor image of the close-up should show the rear or the bumper of
the vehicle at the bottom edge of the screen. The middle of the bumper
should be in the middle of the screen (fig.
k , page 9).
➤
Tighten the two fastening screws of the camera.
Settings for contrast and brightness can be made on the monitor.
NOTE
Connect the camera input for close-up (reversing camera) with
the “C1” connection and the camera input for the long-distance
with the “C2” connection.