Waeco PerfectView CAM50, Инструкция по установке и эксплуатации

Страница: 17 / 44

EN
Mounting the camera
PerfectView CAM50
32
If you want to screw on the camera with self-tapping screws
(fig.
b , page 5)
A
NOTICE! Risk of damage!
The holder may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤ Drill Ø 2 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw the camera bracket on with the 3 x 10 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (fig.
c , page 5)
A
NOTICE! Risk of damage!
Ensure that that nuts cannot be pulled through the body shell when
they are tightened.
Use larger washers or metal plates if necessary.
➤
Drill Ø 3.5 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw the camera bracket on with the M3 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable
(fig.
d , page 5)
I
NOTE
If possible, use available openings – such as ventilation grilles – to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 16 mm diameter.
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill
head to come out
_CAM50.book Seite 32 Montag, 7. Mai 2012 3:12 15