EN
Setting the system
MagicWatch MWE910, 900, 900F
28
8
Setting the system
See fig.
f
to fig.
h
A
NOTICE!
Incorrect settings can impair safe operation.
I
NOTE
To stop setting the parameters without
saving your changes,
or
to stop the entire set-up: refrain from pressing any buttons for a
while.
The control electronics for the front sensors have the following control
elements:
Setting the values
See fig.
g
to fig.
h
.
Configuring the front sensors (MWE910/900F)
You can set the travel speed at which the sensors switch off by connect-
ing the control electronics of the front sensors to the speedometer.
➤
Set parameter
11
to the required value.
You can set a switch-off time for the front sensors if you are unable to con-
nect the control electronics of the front sensors to the speedometer (e.g.
no speedometer signal or signal via a CAN bus adapter such as CBI150).
➤
Set parameter
12
to the required time.
You can set the system so that the front sensors not only display obsta-
cles intermittently but all the time until they are deactivated by the travel
speed or by switching off.
➤
Set parameter
16
to
1
.
No. in fig.
f
Designation
1
Display
F5
Factory settings activated
C5
Your own settings
2, 3
Buttons for setting the system
Содержание magicwatch mwe910
Страница 4: ......
