Waeco MagicSpeed HUD, Инструкция по установке и эксплуатации

Страница: 22 / 104

Using the display
MagicSpeed HUD
22
z To prevent damage to the cables, when laying them ensure that there is
sufficient distance to hot vehicle components (lights, heaters, ventilators etc.).
z Wrap insulating tape around every connection on the cable (even inside the
vehicle).
z
When laying the cables, make sure:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid through sharp-edged ducts without protection (fig.
2
,
page 3).
Caution!
Make sure the polarity is correct when connecting to a voltage source.
➤
Using the cable connectors (fig. 3 3, page 3), connect the three loose ends of
the cable to the corresponding wires (fig. 8 , page 5):
– Connect the red cable to terminal 15 (ignition).
– Connect the black cable to terminal 31 (earth).
– Connect the white cable to the speedometer signal wire.
Note
Our technical support (+49 2572 879-191) maintains a great deal of
vehicle-specific information for locating the speedometer signal wire.
➤ Lay the connection cable on the dashboard.
➤
Insert the plug of the connecting cable (fig. 9 1, page 5) into the socket of the
display (fig.
9
2, page 5).
7 Using the display
7.1 Switching on the display
The display is switched to standby when you turn on the ignition.
✓ All indicators light up for two seconds (fig. 0 , page 5).
When you switch it on, the display tests all the LED segments. Then it switches
to display mode and shows the current travel speed.
_MHUD-100.book Seite 22 Mittwoch, 11. Oktober 2006 9:17 09