Safety and installation instructions
MagicComfort MSH100
18
Only use insulated cable terminals, plugs and flat sockets for releasable
connections. Do
not
use crimp terminals (cable connectors) or terminal
strips.
z
Use a crimping tool (fig.
1
10, page 2) to connect the cables.
z
When connecting to cable 31 (earth), screw the cable
– To the vehicle's earth bolt with a cable lug and a gear disc or
– To the sheet-metal bodywork with a cable lug and a self-tapping
screw.
Ensure that there is a good earth connection.
If you disconnect the negative terminal of the battery, all data stored in the
volatile memories will be lost.
z
The following data must be set again, depending on the vehicle equip-
ment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following installation instructions:
z
Secure the parts installed in the vehicle in such a way that they cannot
become loose under any circumstances (sudden braking, accidents) and
cause
injuries to the occupants
of the vehicle.
z
To prevent damage, when drilling ensure that there is sufficient space on
the other side for the drill head to come out (fig.
2
, page 3).
z
Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
z
When testing the voltage in electrical cables, only use a diode test lamp
(fig.
1
8, page 2) or a voltmeter (fig.
1
9, page 2).
Test lamps with an illuminant (fig.
1
12, page 2) take up voltages which
are too high and which can damage the vehicle's electronic system.
z
When making electrical connections (fig.
3
, page 3), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
_MSH100.book Seite 18 Montag, 6. September 2010 6:37 18
