Waeco ECL-76, Инструкция по установке и эксплуатации

Страница: 109 / 196

ECL-76, ECL-102, ECL-103 Connection
EN
109
Dometic CA1000
I
➤
Remove the CA1000’s outlet panel.
➤
Using the 2-wire on/off cable (sensing cable, item no. 4441300084), connect contacts
I2 and I3 on the ECL-102/ECL-103 to the air conditioner.
➤
Insert the three-pole plug of the sensing cable into the socket (3-pole pin strip socket)
on the control PCB of the air conditioner (fig.
q , page 28).
➤ Set the AC/DC switching parameters for the air conditioner to “02” (

installation
manual for the CA1000, “Configuring the system software”).
Dometic CA2500
➤
Remove the CA2500’s outlet panel.
➤
Connect the charging current distributor to the air conditioner using the 2-wire universal
connection cable (on/off cable, item no. 4441300124).
➤
Connect the wire sleeves of the universal connection cable to contacts 12 and 13
on the charging current distributor.
➤
A cable leading out provides the connection to the circuit board (fig. u , page 30).
Sever this cable and join the resulting cable ends to the universal connection cable.
Dometic B1600 Plus/B2200
I
➤
Remove the B1600 Plus/B2200’s outlet panel, if necessary remove the upper cover.
➤
Connect the wire sleeves of the universal connection cable to contacts I5 and I2 on the
charging current distributor.
➤
Join the on/off cable of the B1600 Plus/B2200 (item no. 4441300129) to the plug
connector on the circuit board (fig.
t , page 30).
I
➤ Connect both the wires on the universal connection cable (4441300124) to the two
wires on the on/off cable of the B1600 Plus/B2200.
NOTE
Observe also the instructions in the scope of delivery of the sensing cable.
NOTE
B2200 with a serial number lower than 802200001 must be installed as
described in chapter 7.4.
NOTE
Guide the on/off cable carefully past the fan.