Waeco CoolMatic HDC-270, Инструкция по установке и эксплуатации

Страница: 43 / 176

HDC-270 Disposal
43
10 Disposal
➤
Place the packaging material in the appropriate recycling waste bins
wherever possible.
M
If you wish to finally dispose of the product, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
11 Troubleshooting
Compressor does not run
Problem Possible cause Remedy
U
KL
= 0 V There is an interruption in the
battery – electronics connection Establish a connection
Main switch faulty (if installed) Replace the main switch
Additional supply line fuse has blown
(if installed) Replace the supply line
fuse
U
KL
= U
ON
Battery voltage is too low Charge the battery
Start attempt with
U
KL
=
U
OFF
Loose cables
Poor contact (corrosion) Establish a connection
Battery capacity too low Replacing the battery
Cable cross section too small Change the cable (see
table on page 37)
Start attempt with
U
KL
=
U
ON
Ambient temperature too high –
Insufficient ventilation Move the refrigerator to
another location
Condenser is dirty Clean the condenser
Fan defective (if installed) Replace the fan
Electric circuit between
the pins in the compres-
sor interrupted Defective compressor Replace the compressor
U
KL
Voltage between the positive and negative terminals of the electronics
U
ON
Cut-in voltage of the electronics
U
OFF
Cut-off voltage of the electronics
_HDC270.book Seite 43 Montag, 18. Oktober 2010 8:12 20