Waeco CoolFreeze CDF16, Руководство по эксплуатации

Страница: 26 / 216

EN
Operation CoolFreeze CDF16
26
In “HIGH” mode, the battery monitor responds faster than at the levels “LOW”
and “MED” (see the following table).
I
➤
Switch on the cooler.
➤
Press the “SET” button three times.
➤
Use the “UP +” and “DOWN -” buttons to select the battery monitor mode.
✓ The selected mode then appears in the display for a few seconds. The
display flashes several times before it returns to the current temperature.
6.5 Using the cooler
A
➤
Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated
air can dissipate.
➤
Press the “ON/OFF” button for three seconds.
✓
The “POWER” LED lights up.
✓
The display switches on and shows the current cooling temperature.
✓ The cooler starts cooling the interior.
Battery monitor mode LOW MED HIGH
Switch-off voltage at 12 V
10,6 V ± 0,3 V 11,4 V ± 0,3 V 11,8 V ± 0,3 V
Restartvoltage at 12 V
11,6 V ± 0,3 V 12,2 V ± 0,3 V 12,6 V ± 0,3 V
Switch-off voltage at 24 V
22,0 V ± 0,3 V 24,1 V ± 0,3 V 24,6 V ± 0,3 V
Restart voltage at 24 V
23,5 V ± 0,3 V 25,3 V ± 0,3 V 26,2 V ± 0,3 V
NOTE
When the cooler is supplied by the starter battery, select the bat-
tery monitor mode “HIGH”. If the cooler is connected to a supply
battery, the battery monitor mode “LOW” will suffice.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate.